Easy ride-on mower maintenance guide
This guide covers Husqvarna ride-on lawn mower maintenance - if you are looking for garden tractor care instead, click here.
Regular maintenance is the key to keeping your Husqvarna ride-on lawn mower performing at its best.
By following a service schedule, you'll:
- Extend the life of your ride-on mower.
- Get a consistent, professional-looking cut.
- Prevent costly repairs down the road.
DIY maintenance you can do at home
Safety first
Always use the right protective equipment and make sure the mower is switched off before starting any maintenance.
After 50 hours - first service (or once a year)
Petrol-powered ride-on mower
Petrol-powered ride-on mower
- Check and adjust tyre pressure.
- Clean the air filter.
- Replace the engine oil and oil filter.
- Inspect lights and replace if necessary (if applicable).
- Check and charge the starter battery.
- Clean the cutting deck (inside and out).
- Adjust cutting height and pitch for correct ground pressure.
- Test blade engagement, seat, lift, drive, and brakes.
- Inspect the collection system (if applicable).
Battery ride-on mower
Battery ride-on mower
- Clean the cutting deck inside and out.
- Check tyre pressure.
- Adjust cutting deck parallelism if needed.
After 100 hours
Petrol ride-on mower
Petrol ride-on mower
- Replace the fuel filter.
- Replace the air filter.
- Replace the engine oil.
- Replace the spark plug.
- Check and top up transmission oil.
- Inspect lights, battery, and electrical system.
- Clean the cutting deck thoroughly.
- Re-check tyre pressure, cutting height, pitch, and ground pressure.
- Test blade engagement, seat, lift, drive, and brakes.
- Inspect the collection system.
After 200 hours - dealer maintenance
Some tasks require specialist tools and training.
At the 200-hour mark, or if you are unsure, visit your local authorized Husqvarna dealer for expert service.
They will perform advance checks and ensure your ride-on mower continues to meet factory standards.
Was this article helpful?
