How to clean and replace a surface cleaner nozzle on a high-pressure washer
When using your high-pressure washer with a surface cleaner accessory, you may experience uneven pressure or streaky cleaning results.
This is often caused by a nozzle that is either clogged with debris or damaged from wear.
Cleaning a surface cleaner nozzle
- Remove the security pin from the nozzle.
- Detach the nozzle from the spinner.
- Clean the nozzle hole by running a cleaning pin through it to remove dirt or debris.
- You can use the cleaning pin provided with your high-pressure washer. - Reinstall the nozzle and secure it with the pin.
Replacing a surface cleaner nozzle
NOTE: Some Husqvarna® surface cleaner models come with extra high-intensity nozzles stored in a special nozzle compartment, directly on the accessory.
- Remove the security pin from the nozzle.
- Detach the old nozzle from the spinner.
- Fit the new nozzle into place.
- Secure it with the pin and double-check that it’s firmly attached.
Pro tips for best performance
- Clean nozzles regularly to avoid clogging and uneven spray.
- Replace worn or damaged nozzles promptly for optimal cleaning results.
- Store extra nozzles in their dedicated compartment (if available) to keep them safe and ready for use.
Surface cleaner nozzle FAQ
This usually happens when one or both nozzles are clogged or damaged. Cleaning or replacing the nozzles will restore even water flow and consistent cleaning.
It’s a good idea to clean the nozzles after every few uses, especially if you’re working in areas with dirt, sand or hard water that can cause buildup.
If the nozzle is cracked, worn down or still not spraying evenly after cleaning, it should be replaced with a genuine Husqvarna® nozzle.
No. Always use nozzles that are designed for your specific Husqvarna® high-pressure washer model to ensure proper fit and performance.
A clogged nozzle reduces cleaning efficiency, causes uneven results and puts extra strain on your washer’s pump. Regular cleaning prevents these issues.