How to change engine oil in a snow blower
Regular engine oil changes help keep your Husqvarna snow blower running smoothly and extend its engine life.
Safety first
- Turn off the engine and remove the ON/OFF key.
- Wait until all moving parts stop (auger and impeller).
- Disconnect the spark plug wire and keep it away from the spark plug.
- If engine oil gets on your skin, wash immediately with soap and water.
- Make sure that the snow blower is stable and on level ground.
Follow these simple steps to replace the oil safely and correctly.
Tools you will need
- Protective gloves
- Oil drain container
- Small funnel or channel
- Clean cloth or paper towels
- Fresh engine oil—check the operator’s manual of your product for the correct oil type
Before you start
If the engine is cold, run it for 1–2 minutes to warm up the oil. Warm oil drains faster and more completely.
Changing the engine oil in your Husqvarna snow blower is a quick and simple maintenance task. For most customers, it takes about 30 minutesfrom start to finish, depending on experience and setup.
Step-by-step snow blower oil change
- Place the snow blower on flat, level ground.
- Place an oil drain container underneath the oil plug.
- Use a channel or funnel to direct the oil flow into the container.
- Remove the oil plug and let the used oil drain completely.
- Once drained, reinstall the oil plug securely.
- Fill the engine with the recommended amount of fresh oil.
- Check the oil level using the dipstick and top up if needed.
Final tips
- Always use the correct engine oil type listed in the operator’s manual for your product.
- Dispose of used oil responsibly at a local recycling centre.
- Change your engine oil at least once per season after every 25 hours of use.
Was this article helpful?