High-pressure washer hose won’t pull out? Causes and fixes

If you are trying to use your Husqvarna high-pressure washer and notice that the hose won’t pull out, don’t worry—we have solutions!

It usually happens because the hose or hose reel is blocked or tangled.

With a few simple checks, you can get your washer working smoothly again.

Dirt and debris blocking the hose outlet

Sometimes dirt and small debris can get stuck in the house outlet, preventing the hose from moving freely.

Solutions

• Gently manipulate or wiggle the hose to help release any dirt.
• Check the outlet and clean it if needed.

Hose tangled inside the hose reel

If a high-pressure washer has an internal hose reel

• The hose may get tangled if you hold it too tightly while winding it back.
• Always let the system guide the hose into the reel automatically.
• To release the hose:

1. Pull the hose gently while unwinding the reel.
2. If needed, remove the hose reel cover for better access.
3. Take out the pin and pull the hose from the opposite direction.
4. Clean the hose reel with a dry cloth to prevent future tangles.

If a high-pressure washer has an external reel

• Tangling can also happen if the hose is wound up incorrectly.
• Let the system roll up the hose so it stays properly aligned.
• To release the hose, gently pull it while unwinding the reel.

Final tip

Always store your high-pressure washer hose neatly and avoid forcing it into the reel. This will prevent tangles and extend the life of the hose.