How to clean a water filter on a high-pressure washer
Your Husqvarna® high-pressure washer relies on a clean water filter to prevent dirt and debris from entering the system.
Over time, the filter can get dirty or blocked, especially with frequent use.
If the water filter becomes clogged, it may cut off the water supply completely—resulting in no water coming out of the washer.
To keep your washer in top condition, we recommend cleaning the water filter after every use.
Why cleaning the water filter matters
Prevents blockage
- Stops dirt and sand from building up inside the washer.
Ensures water flow
- Keeps a steady supply of water for consistent pressure.
Protects the pump
- Reduces the risk of damage caused by debris entering the system.
When connecting to a garden hose, always make sure to follow the correct steps. If debris enters the hose, it can quickly accumulate in the filter and cause a blockage.
Cleaning a water filter
Safety first
WARNING: Always turn the power switch to OFF (0) and unplug the power cord before performing maintenance.
Step-by-step water filter cleaning
- Remove the coupling on the front of your high-pressure washer.
- Pull out the water filter using a pair of pliers.
- Clean the filter
- Tap it gently to remove loose dirt.
- Rinse it thoroughly under running water. - Fit the filter back into the washer.
- Secure the connector by screwing the coupling back on.
Your washer is now ready for use again with a clean, unblocked water filter.
Pro tips for maintenance
- Clean the water filter after every use to avoid blockages.
- Store hoses and accessories clean and dry to reduce debris entering the system.
- Replace the filter if it shows signs of damage or excessive wear.
Water filter FAQ
A common reason is a clogged water filter that blocks the flow of water. Cleaning or replacing the filter usually solves the problem.
We recommend cleaning the water filter after every use. This prevents blockages and ensures a steady water supply.
If the filter is cracked, damaged or still blocked after rinsing, it should be replaced with a genuine Husqvarna® water filter.
No. Running the washer without a filter allows dirt and debris to enter the pump, which can cause serious damage.
Debris in your garden hose or water source often clogs the filter. Always flush the hose before connecting it to the washer to reduce the risk of blockages.