Installation films

To see how to install Automower®, take a look at these movies.

You need to have Adobe Flash Player installed on your computer to view the installation films.

Introduction

Before Automower® can be started, the charging station and the boundary wire must be installed and the mower must be linked to the charging station. These movies provide a quick step-by-step guide to installing Automower®. You can watch each step by clicking the play icon and then using the movie controls.

STEP 1 - Placing and connecting the charging station

Place the charging station on level ground centrally in the main area with a large free area in front of it, and tap the pegs through the holes in the base plate to secure it to the ground. Connect the low voltage cable to the charging station and the transformer, and connect the transformer´s power cord to a wall socket.

STEP 3 - Cutting heights and mower settings

To adjust the cutting height, open the lid of Automower® and turn the knob to the desired position and close the lid. On the top of Automower® there is a control panel behind the clear door. All mower settings such as operating times, PIN code, movement patterns etc can be managed via the main and submenu functions. Complete menu functions can be found in the user manual that you can download from this site.

STEP 5 - Automatic recharging

Automower® will recharge itself by docking into its charging station. This happens when the power levels of the battery becomes too low. The charging station sends out a signal that Automower® can sense at a distance of up to 25 feet. When the mower seeks out its charging station, it reserves its power supply by ceasing to mow. It normally finds the charging station within a few minutes.