the little saw that could
This saw is lighter than most chainsaws of its size, powerful prenty of torq what a little beast. I picked one of these saws up at Lowe's and i got more than i expected . the one i bought i believe has the same motor as the 450. Its a 2011.
i converted the automatic oil pump to an ajustable much better next im going to swap to drum sprocket and i think i can put an aluminum handle on it. I dont care about the warranty as long as u take care of the saw it should last half your life time. I lighty blow out around the motor with the air compressor every time im done cutting and grease the sprocket bearing in the cluch and bar . great saw. this doesnt have anything to to with the saw but the Husqvarna bar oil is low in viscosity to me it doent stick the the chain at hi speeds great for winter but not for summer i also have a 353 e tech love them both. the 353 runs so nice aways starts the first pop on the pull when warm. oh one more thing i would recomend using the decompression valve on the the xtorg saws my 445 kicked back when sarting it real hard one day and caught the sarter pulley and broke it. rare to happen. just bad luck. happened on friday the 13th user error. one other slight problem is the casing around the chain and sprcoket isnt open enough for chips to get out and they go back around and jam the bar sometimes guess thats what u get for sharping with a 7/32 file on a new chain haha flat chissel chain. recommend chipper chain in hard wood bore cuts much smoother i gap my plugs a little more than the recomended better engine response better starting from my experince i clean them once a month on a wire wheel and replace it once a year works for me. Ive done some brush clearing and some felling with it. i bought it in July this year. can someone tell me if felling dogs from a 357 will fit my 353 or a good set a reason why i shouldnt run a 3/8 chain on either of these two saws was thinking a 22inch bar and good set of felling dogs for my 353 to balance it out at the bar end i found an oregon 3/8 standard drum that fits
September 18, 2012
One of the best saws I have ever used.Had Sthil in past.Cranks everytime withtn 2 pulls.More than enough power.Cut 3 to 4 cords of firewood a year.
August 30, 2012
Husky chainsaw 445
Worst piece of equipment I have ever owned. Engine floods everytime I try to start it. Totally useless and ready for the scrap yard. Yes I watched the movie and read the manual. I suspect the problem is in the carb.
August 29, 2012
This product is reliable
Bought this saw when I had three trees die this year. This is my forth chainsaw I have purchased and is by far the easiest to use. Cranks very easy and is light enough in weight to allow you to keep working.
August 13, 2012
this saw is the best lite weight saw I have ever used I use this saw for professional tree service use on very large trees and on the Alaskan Saw Mill to bard out some of the logs to make tables and book cases the saw cuts like a dream and handles great I have dropped many trees 35-40 inches in diameter and it does not take long with the 20 inch bar I would recommend this saw for any job big or small it is the best saw made.
August 2, 2012
If you need a saw, get this one!!!
I bought the saw without reading any reviews or researching when a tree fell in my yard. It it POWERFUL!! It was a snap to put together and started right up! I would recommend this machine to anyone!
August 1, 2012
best little saw for the money
great saw highly recomend this saw cuts like a knife through butter awsome power with 16 inch bar.will cut any tree big or little you just have to take time on big trees because of the 16 inches but it will cut it up easy,./
July 29, 2012
Starts right up runs like a champ plenty of power. I turned it off to refuel and had problems starting it my way thinking the instructions printed on it were written wrong. When I started it according to instructions it fired right up. It pays to read all instructions.
July 20, 2012